Setup Of Network Parameters - Avaya DECT R4 Installation And Administration Manual

Figure 183: Connection of Ethernet cable
Ethernet

Setup of network parameters

1. Set section one in SW3 to ON to set Elise 2 Server (AIWS Hardware) in "Network setup
mode". The remaining sections should be set to OFF.
Figure 184: Setting the Elise 2 Server (AIWS Hardware) in Network setup mode.
OFF ON
1
SW3
8
2. Connect Elise 2 Server (AIWS Hardware) Ethernet connector J20 either
with crossover cable directly to a PC or
●
with ordinary (straight through pinouts) cable via a HUB on the LAN to the PC.
●
Observe that it has to be the same LAN, i.e. same Ethernet Broadcast Domain.
3. Connect the power cable and wait until the Function Indicator indicates with steadily
orange light. Elise 2 Server (AIWS Hardware) now has the network setup IP address
192.5.36.229.
If the function indicator is red, check that supply voltage is 12.5 Vdc ±10%.
Avaya DECT R4 - Installation and Maintenance Guide
Installation
545
02/2016