Technical Specification - Avaya DECT R4 Installation And Administration Manual

Installing and operating the AIWS and the AIWS2
Note:
If an LDAP connection to a central phonebook is used, all settings needed is
Note:
done in the setup wizard.

Technical Specification

The local database has defined limitations while most of the limitations for the LDAP server
depends on the LDAP server used, see table below.
Max. No. of phonebook entries:
Max. No. of characters in family name:
Max. No. of characters in first name:
Max. No. of digits in phone number:
Max. No. of returned entries / request:
telephones that can access the phonebook
1. See also documentation for the telephone
Phonebook address
When the Unite Name Server (UNS) is set to forwarding mode, the phonebook Call ID must
exist in the module that the requests are sent to. Any change of the Call ID and/or IP address
must be made in that module. If the default address is used, no changes are needed. When the
UNS is set to stand-alone mode, do as follows to change the address:
The default Call ID is 999999 for phonebook access.
1. On the AIWS start page, click on Configuration. The AIWS Configuration page opens.
2. In the left pane, click Other settings > Advanced configuration. The AIWS Advanced
Configuration page opens.
3. In the left pane, under Other, click UNS
4. Click on Alias / Call ID.
5. Click 999999 in the list.
6. Enter the new Call ID for the phonebook, i.e. the Call ID the telephones are using to
access the phonebook. Check that the Call ID does not conflict with any of the telephones
in the system.
7. If the phonebook is located on another module, enter the IP address to that module.
1.
444
Avaya DECT R4 - Installation and Maintenance Guide
1
Local Database
500/2000
20
20
20
25
1
Depends on telephone type
LDAP Server
Server dependent
Server dependent
Server dependent
Server dependent
25
02/2016