Avaya DECT R4 Installation And Administration Manual page 300

Installing and operating the Rackmount Charger
Inlet accessory kit including cable support holders and screws
●
Note:
An extension cord IEC C14 AC connector (female IEC60320-C13) to wall socket
Note:
(IEC60320-C14) has to be ordered separately. It shall be connected between the
pre-installed IEC C14 AC connector (male) and the wall socket.
Required Tools etc.
Screwdrivers
●
Cutting pliers
●
Multimeter
●
Screws and wall plugs for wall mounting. Make sure the screws and wall plugs have the
●
correct length for the type of wall used. See example below:
Wall material
Single plasterboard
Double plasterboard
Concrete
Examples of ways to mount the Rackmount Chargers
Different ways to mount CR3 Rack Chargers is shown in
set up different combinations of CR3 Rack Chargers and Battery Pack Chargers. A maximum of
four CR3 Rack Chargers (or Battery Pack Chargers) can be serially connected to the same LAN
source.
Installation steps
The installation is done in three steps:
1. Wall mounting.
2. Electrical installation.
3. Communication cable connection.
Wall mounting
First, make an outline of how the Rackmount Chargers are to be placed.
Tip: If several Rackmount Chargers (or Multiple Battery Charger) are to be mounted close to
each other, mount them so that there is enough space between them to be able to disconnect
the telephones (vertical distance) and to be able to open the top cover (horizontal distance).
Tip: When you are planning the location of the modules, start to mount them in a height that
makes it easy to reach the cordless telephones and to read the cordless telephones' display.
300
Avaya DECT R4 - Installation and Maintenance Guide
Plug length Screw diameter
Thorsman TP1 3.5 – 5 mm
Thorsman TP2 3.5 – 5 mm
Thorsman TP2 3.5 – 5 mm
figure 73 on page 303. It is possible to
02/2016