Rackmount Charger - Avaya DECT R4 Installation And Administration Manual

Rackmount Charger

For general LED indications, see also
Status LED on the charger is not lit.
Check that power is supplied.
If power is supplied and the status LED is still not lit, the probable cause is a software error.
Connect charger to PDM via USB and check if charger goes online. If yes check software
version of the charger. Send charger for service.
Status LED on the charger is fixed red.
Connect charger to PDM via USB and check if charger goes online. If yes check software
version of the charger. Send charger for service.
Status LED is flashing red for 3s, then green
A factory reset has been performed. It may be necessary to set parameters from PDM/AIWS.
Status LED is flashing red (100 ms on, 800 ms off) for more than 3s
An error occurred during Easy Replacement. Remove portable from charger.
Status LED is flashing red (100 ms on, 800 ms off) for more than 3s
If the error occurred during Easy Replacement, remove the portable from the charger. The
charger should return to normal operation.
Otherwise send charger for service.
Charging does not start
Check that the telephone is properly inserted in the charger.
Rackmount Charger does not appear in PDM/AIWS.
Check that the communication cable (USB or Ethernet) is connected.
If charger doesn't appear in the AIWS device manager when connected via Ethernet you might
have to configure the AIWS IP-address with the PDM tool (refer to
appear in AIWS
Easy Handset Replacement doesn't start at the Rackmount Charger
Easy handset replacement is only supported in the first slot (most left) of the Rackmount
Charger.
Avaya DECT R4 - Installation and Maintenance Guide
on page 274).
LED indications on page 312.
Rackmount Charger
Advanced Charger does not
02/2016
689