Restoring The Configuration - Avaya DECT R4 Installation And Administration Manual

Restoring the configuration

Note:
When the AIWS is restored, all changes that have been made since the last
Note:
backup will be discarded.
1. Click Configuration on the start page.
2. Select Other Settings > Backup/Restore. The Backup / Restore view appears.
3. Click Browse... and select the backup file.
4. Click the Restore button. An information window will open and inform you when the
restore is ready.
5. Click "Restart Now" to reboot, else click "Restart Later". If the IP address or DECT
interface has been changed the module needs to be restarted for the settings to take
effect.
A restart will take a couple of minutes and during that time the module cannot be reached.
When the restart is completed, the window will refresh to the Configuration page overview.
Since the .bin files are not restored, this has to be done manually. See
for devices on page 428 or
Restore of NetPage files is described in
!
Important:
A backup file taken on the Elise 2 (AIWS Hardware) can be reused to restore the
Important:
configuration on the Elise 3 (AIWS2 hardware).
Device configuration
Device Management setup
This setup page is used to set addresses to theUnite modules that have the Device manager
enabled. Additionally a service dedicated to the interface (for example the IP-DECT)T devices
that are connected is also added to the address. The specified interfaces then inform the Device
Manager about all devices that are logged in.
Avaya DECT R4 - Installation and Maintenance Guide
Importing new software for devices
Files for Translation/Editing
Basic Configuration
Importing new software
on page 428.
on page 482.
02/2016
461