Installing An Image On An Empty Compact Flash - Avaya DECT R4 Installation And Administration Manual

Installing Elise 2 Server (AIWS Hardware)
Note:
The .img file must be used to update the complete image on the Compact Flash.
Note:
6. Restore the old AIWS configuration from the backup that was taken before. Without
restoring all parameters especially the network setup and license key will get lost after
reboot.
7. Press reboot to start the AIWS with the new software image
It is possible to replace the image over a remote connection. However, note that it is not
possible to replace the image on the Elise 2 Server (AIWS Hardware) that handles the remote
connection.

Installing an image on an empty Compact Flash

An image can also be installed on an empty Compact Flash.
1. Set section one and four in SW3 to ON, to set the Elise 2 Server (AIWS Hardware) in
"Network setup mode" and "Image installation mode".
2. Perform a power down of the unit and then restart it, see
Elise 2 Server (AIWS Hardware)
3. Use the program "Route to ELISE" to connect to the Elise 2 Server (AIWS Hardware). A
web page where a new image can be installed will open.
4. Select the image to install. Note that it will take some time to install the new image. The
time is dependent of the size of the image and the type of connection to the Elise 2 Server
(AIWS Hardware).
Note:
The .img file must be used to update the complete image on the Compact Flash.
Note:
552
Avaya DECT R4 - Installation and Maintenance Guide
on page 527.
Powering down and restarting the
02/2016