Avaya DECT R4 Installation And Administration Manual page 155

3. If you have selected the "Mirror" mode enter the IP address to the other Mirror Master in
the Mirror Master IP address text field.
For the Master that initially shall be the active Mirror: Click on the text link "Activate mirror".
Any user and handset data in the inactive Mirror will be replaced with the user and handset
data stored in the active Mirror.
To switch the active role between the Mirror Masters, click on the text link "Switch active
mirror". Note: This should be done within a maintenance window as all active calls will be
lost.
4. Click OK.
5. Reset in order to make the changes take effect, see
Entering admin password
1. Select DECT > System.
2. Enter password.
Note:
Create a backup of the IPBS/IPBL configuration when you change the
Note:
administrator password. See
Configuring Master ID
Only applicable on the Master and standby Master.
You only need the Master ID configuration in a Multi Base Station Master scenario. For a single
IPBS/IPBL Master, use Master ID 0.
In a Multi Base Station Master scenario, configure an individual Master ID for each IPBS/IPBL
Master in the range of 0 and 250. Use Master ID "0" for IPBS/IPBL Master1, which is the LDAP
server of the IP-DECT system. All further IPBS/IPBL Masters doing the LDAP replication should
use a Master ID from 1 to 250.
A standby Master must use the same Master ID as the corresponding IPBS/IPBL Master.
Configuring IP-PBX
Only applicable on the Master.
1. Select DECT > Master.
2. Select PBX.
3. Enter the ARS Prefix, for example, 00 for calling outside the building.
4. Enter the International CPN Prefix, for example, 0046 for Sweden.
5. Enter the National CPN Prefix, for example, 031 for Göteborg.
Avaya DECT R4 - Installation and Maintenance Guide
Reset
Backing up on page 182.
Operation
on page 190.
02/2016
155