Reset Using The Reset Button - Avaya DECT R4 Installation And Administration Manual

Idle Reset
1. Select Reset > Idle Reset.
2. Click OK.
3. The IPBS will reset when there are no active calls.
Immediate reset
1. Select Reset > Reset.
2. Click OK.
3. The IPBS will terminate all active calls and reset.
TFTP mode
Note:
When the IPBS/IPBL is in TFTP mode it can only be reached using the gwload
Note:
utility. This mode should not be used during normal operation.
Boot
When the IPBS/IPBL is in Boot mode, it uses a small version of the firmware (minifirmware)
which contains only the IP stack and the web interface.
1. Select Reset > Boot.
2. Click OK.

Reset using the reset button

It is possible to perform a hardware reset of the IPBS and the IPBL by pressing the reset button.
The button is accessed through a hole in the back of the IPBS
Avaya DECT R4 - Installation and Maintenance Guide
(figure 14 on page 65).
02/2016
Operation
191