Avaya DECT R4 Installation And Administration Manual page 175

3. In the Add Radio window enter a name for the device. You can also add a Standby Master
IP Address.
4. Click OK.
The Radio restarts and it establishes a connection to the PARI Master only.
Name
RFPI
IP Address
Sync
Region
Device Name
LDAP
Version
Connected Time
Add Radios
1. In the Uninitalized Registrations section, uninitialized Radios not registered to a Master are
shown.
2. Select Device Overview > Radios
3. Click "Add" to add the Radio to the Master.
4. In the Add Radio window enter a name for the device. You can also add a Standby Master
IP Address and a Sync Region.
5. Click "OK".
6. The Radio restarts and it establishes a connection to the Master only.
Deleting radios
In the Static Registrations section, initialized Radios no longer registered to the PARI Master are
shown.
1. Select Device Overview > Radios
2. In the Static Registrations section, click Delete to delete the Radio.
The Radio's RFPI is now released and can be reused. All other RFPIs in use are not
affected.
Avaya DECT R4 - Installation and Maintenance Guide
The unique identification name. The name syntax is ipbs-xx-xx-xx,
where xx-xx-xx should be replaced with the last 6 hexadecimal digits of
the MAC address.
Radio Fixed Part Identity.
The IP address, click on the IP address to access the configuration GUI
of that IPBS.
The current synchronization status.
Should be Master OK or Slave OK if synchronized.
Sync region, the radio is currently assigned.
The name entered in the general menu.
The LDAP status, can be "" (blank), "-", "up", "server" or "down".
Should be "-", "up" or "server".
The current software version.
The elapsed time since connected to the Master.
Operation
175
02/2016