Selecting Operating Mode - Avaya DECT R4 Installation And Administration Manual

Unlicensed Mode
It is possible to run the Elise 2 Server (AIWS Hardware), with full functionality for two hours,
without a license. Exact functionality is application dependent. For more information about the
functionality during unlicensed mode, see the application documentation.
In unlicensed mode, it is possible to enter a license that does not match the current hardware.
This makes it possible to configure a Compact Flash on one hardware and move the Compact
Flash to another hardware without changing the license.

Selecting operating mode

All 8 sections of SW3 are set to OFF for normal operating mode.
Figure 169: Switch for selection of operating mode.
OFF ON
1
SW3
8
Section 1:
Section 2:
Section 3:
Section 4:
Section 5:
Section 6:
Section 7:
Section 8:
Changing Operating Mode
1. Set the section that corresponds to the operating mode to ON.
2. Open the administration web page and press "Reboot" or follow the instructions in
Powering down and restarting the Elise 2 Server (AIWS Hardware)
Starting the unit in Normal Mode
1. Set all sections on SW3 to OFF.
Avaya DECT R4 - Installation and Maintenance Guide
Network setup mode
Fail-safe mode
Not used, must be set to OFF
Image Installation mode
Unlicensed mode
Not used, must be set to OFF
Not used, must be set to OFF
Not used, must be set to OFF
General information
on page 527.
529
02/2016