Avaya DECT R4 Installation And Administration Manual page 199

mod cmd UP0 boot http://192.168.0.10/firm ireset 5.0.0
The command above determines if the boot code 5.0.5 is already installed. If not, new boot
code will be downloaded fromthe following locations:
IPBS1: http://192.168.0.10/firm/boot_ipbs.bin,
IPBS2:http://192.168.0.10/firm/boot_ipbs2.bin
IPBL: http://192.168.0.10/boot_ipbl.bin
The UPDATE/BOOT variable will be set to 5.0.5 and the device will be reset as soon as it is idle.
Using UP0, device configurations can be saved to a web server.
mod cmd UP0 scfg <url>
This command will cause the device to upload its current config to url This will be done using an
HTTP PUT command. url must be writable thus. With url, some meta character strings are
replaced as follows:
Sequence
#d
#m
#h
Setting the RFP_UPDATE0 parameter
To perform a RFP firmware update, use the following commands.
mod cmd RFP_UPDATE0 firmware http://192.168.0.10/Worf4_GAP_R4H.s2
The command above specifies the url to the RFP firmware to use.
mod cmd RFP_UPDATE0 select 0x2753
Specifies which RFPs to update using a hex-encoded bit-mask. Each bit represents an RFP
port starting with port 1 at the LSB (0x0001) up to port 16 (0x8000).
0x2753 specifies RFP "1,2,5,7,9,10,11,14" to be updated.
mod cmd RFP_UPDATE0 schedule DD.MM.YYYY-HH:MM
Specifies when the update shall start. If no date is provided, the update will be immediate when
the start command is issued.
Avaya DECT R4 - Installation and Maintenance Guide
IPBS1
IPBS2
IPBL
Replacement
Current date and time
Primary device mac address
Device hardware ID
boot_ipbs.bin
boot_ipbs2.bin
boot_ipbl.bin
Example
20040319-162544
00-90-33-03-0d-f0
ipbs-03-0d-f0
Using the Update Server
199
02/2016