Administration And Authentication - Avaya DECT R4 Installation And Administration Manual

1
Fail safe mode is indicated, even if SW3 pin 2 is not set to ON, if the application on Elise 2 Server (AIWS
Hardware) is not completely installed or when the application part of the Compact Flash is erased.
2
When Elise 2 Server (AIWS Hardware) is in Network setup mode, this will always be indicated and override
LED indications of other simultaneously activated modes, for example Image installation mode.
3
Starting up mode is indicated during start of applications or if an application has lost connection to a
required resource, for example A-bus or connected IPBS Master or NTP server.

Administration and authentication

Administration on Elise 2 Server (AIWS Hardware) is done from a web browser. In order to
access the administration pages a user name and password have to be given.
!
Important:
The default passwords have to be changed, else anyone with knowledge of a
Important:
password and the IP address can access the administration web pages and make
changes.
Authentication
There are two different users in all Elise 2 Server (AIWS Hardware) products; admin and
sysadmin.
The user admin has the default password "changeme" and is used for administration and simple
troubleshooting of the product. The admin has permission to change all passwords except the
sysadmin password.
The user sysadmin has the default password "setmeup" and is used for advanced
troubleshooting. The user also has access to all administration pages. The sysadmin has
permission to change passwords for all users in the product.
In addition, there are two other users in some Elise 2 Server (AIWS Hardware) products. One is
called user and the default password is "password". This user is product dependent and what it
is used for is described in corresponding product documentation. This user does not have
access to the administration pages where passwords normally are changed. The user can
change its own password on the following page;
user_chpass.shtml. The password can also be changed by the users admin and sysadmin.
The other user is called ftpuser and the default password is "changemetoo". The user is
available in products with a FTP area. The user can change its own password on the following
page; http://xxx.xxx.xxx.xxx/admin/public/ftpuser_chpass.shtml.
Administration
To access the web pages below, the user admin is used.
The web page "xxx.xxx.xxx.xxx/admin" is used in most occasions, for example:
System setup, for example System 900 configuration
●
Avaya DECT R4 - Installation and Maintenance Guide
http://xxx.xxx.xxx.xxx/admin/public/
General information
531
02/2016