Avaya DECT R4 Installation And Administration Manual page 84

Installing and operating the IPBS and IPBL
Pinning
1. Cut the cable to the correct length and connect the cable to a RJ45 modular jack.
2. For more information on pinning the data jack of the IPBS1, see
page 84.
3. For more information on pinning the data jack for the IPBS2, see
page 85
Do not plug the connector in the base station yet.
Note:
Because the distance between the base station and the wall is limited, a RJ45
Note:
modular jack without cable retention must be used.
Pinning the IPBS cable
Figure 20: Connector pinning of the LAN/PoE connector, power feed over the spare cable
pairs
RJ 45 Modular Jack
Figure notes:
Tx = Transmitter data pair
Pwr = Power pairs
84
Avaya DECT R4 - Installation and Maintenance Guide
1 2 3 4 5 6 7 8
Rx = Receiver data pair
Pinning the IPBS cable
Pinning the IPBS2 on
02/2016
on