Accessing The Product - Avaya DECT R4 Installation And Administration Manual

Installing and operating the AIWS and the AIWS2

Accessing the Product

This product can be accessed either via an IP network or directly via the management port
(mini-USB). The web browser Internet Explorer 8.0 or later is recommended for accessing the
product's web interface.
Access via a Network with a DHCP Server
It is recommended that this product always gets the same IP address if it communicates with
other equipment, in order to prevent it from losing contact with the equipment after a restart.
Inform the network administrator about the MAC address (found on a label on the products rear
side) and ask to reserve a fixed IP address in the DHCP server.
1. Connect the module to the LAN.
2. Connect the power supply. Starting up is indicated on the status LED with fast flashing blue
light.
3. When the starting up indication has stopped, open a web browser on your computer and
enter the address elise-XXXXXXXX, where XXXXXXXX is the module key number
(starting zeros can be excluded). The module key number can be found on a label on the
products rear side, and also in the separately ordered license certificate.
Access via the Management port
Note:
A port driver needs to be installed on your computer the first time it is used for
Note:
accessing the product via the management port. The port driver is located on the
product.
Note:
The installation of the port driver differs depending on the computer's operating
Note:
system, see either
Install the Port Driver on Windows 7
1. Connect the power supply. Starting up is indicated on the status LED with fast flashing blue
light.
2. Connect a mini-USB type B cable between the USB port on your computer and the
management port on the module.
3. If the required port driver is not installed on the computer, install it now. See port driver
installation.
510
Avaya DECT R4 - Installation and Maintenance Guide
Install the Port Driver on Windows XP/Vista
on page 512.
on page 511 or
02/2016