Unite Name Server (Uns) - Avaya DECT R4 Installation And Administration Manual

Installing Elise 2 Server (AIWS Hardware)

Unite Name Server (UNS)

The UNS is used to resolve addresses into complete Unite destinations. The Elise 2 Server
(AIWS Hardware) can be configured to send all requests to the local UNS (stand-alone mode)
or to forward all requests to a centralised UNS (forwarding mode). In forwarding mode, the local
UNS will only be used if the centralised UNS cannot resolve the address.
Maintenance information for the AIWS
Replacement of the Compact Flash
Note:
Only Compact Flashes can be used.
Note:
1. Remove the cover, see
2. Perform a power down of the unit, see
(AIWS Hardware)
3. Remove the circuit board, see
4. Replace the Compact Flash.
5. Put the circuit board back into the cabinet.
6. If the Compact Flash is not preprogrammed with a valid IP address follow the instructions
in Setup of network parameters
7. Replace the cover.
Updating application software
The application software on the Compact Flash can be updated, for example if new functionality
for the application has been released. The version of the application software has to be
compatible with the Elise 2 Server (AIWS Hardware) operating system version. See Replacing
an image on the Compact Flash below for information about how to upgrade the operating
system.
The AIWS device manager needs to be closed before the software update can be started.
Otherwise, the software upgrade will not start until the AIWS device manager will be closed.
There is no additional indication or warning text that the AIWS Device manager is still open.
550
Avaya DECT R4 - Installation and Maintenance Guide
Opening the housing
Powering down and restarting the Elise 2 Server
on page 527.
Circuit board replacement
on page 545 else connect the power cable.
on page 533.
on page 553.
02/2016