Quit Operation; Commissioning - Avaya DECT R4 Installation And Administration Manual

Installing and operating the IPBS and IPBL
Note:
Use a pointed object in an non conducting material to perform a reset.
Note:
Short press < 1 sec
Medium press ~ 3 sec
For IPBS2: When 3
seconds have passed,
the LED on IPBS2 will
start flashing in blue
and the reset button
can be released.
Long press ~ 10 sec
For IPBS2: When 10
seconds have passed,
the LED on IPBS2 will
start flashing in blue.
The reset button can
then be released.
When the LED (LED 1
for IPBS1) is steady
amber/yellow, the
factory reset process
is complete.

Quit operation

To end operating the IPBS/IPBL web interface simply close the web browser. There is no logout
or change account option in the web application.

Commissioning

This section describes the visual inspection and tests that must be executed after completing
the installation and initialization of the IP-DECT system. The purpose of the visual inspection
and tests is to verify that all installation activities have resulted in a correctly functioning system.
If it appears that a part is malfunctioning while the system is installed correctly (i.e.: no cabling
faults, no configuration faults), the technician must consult the maintenance section included in
this manual for fault finding.
192
Avaya DECT R4 - Installation and Maintenance Guide
Restart
Restart in TFTP mode. In TFTP mode the IPBS and IPBL can be
accessed only through the gwload application. This mode is intended
for support and development departments.
Factory reset - all configuration parameters will be set to default
values.
02/2016