Avaya DECT R4 Installation And Administration Manual page 288

Installing Multiple Battery Charger
2. Place a battery in the charging slot.
3. A yellow LED indicates that charging starts while a green LED indicates a fully charged
battery.
Power supply by fixed connection
Note:
If the rack charger shall be connected with a fixed connection, the AC connection
Note:
must be done by a authorized electrician.
Tip:
It is possible to use any one of the two AC terminal blocks for AC input.
Tip:
Consequently, the unused terminal block may be used to connect the next rack
charger or battery pack charger.
The Power Supply module connects to 100-240VAC/0.7A 50/60 Hz. When working with the
units, the main power supply cable must always be disconnected. The safety covers must be
mounted on top of the power supply terminal blocks to prevent hazardous situations, like
electric chock.
Figure 65: .Examples of how Multiple Battery Charger can be mounted and connected to a
power source
To disconnect device
Opening the top cover
Open the top cover by first pressing on the sides of the top cover, then lifting it upwards.
288
Avaya DECT R4 - Installation and Maintenance Guide
To disconnect device
02/2016