Avaya DECT R4 Installation And Administration Manual page 198

Installing and operating the IPBS and IPBL
The command above suppresses any command file processing within the first six minutes after
each boot of the device. If /initial is set, new devices (or those that have been reset to factory
settings), the command file will be retrieved even if it normally would be suppressed by the /
allow parameter. This allows new devices to retrieve a site specific standard configuration
quickly.
Setting the UP0 Parameters
To perform a firmware update, use the following command:
mod cmd UP0 prot <url> <final-command> <build-serial>
The command above downloads the new firmware from <url> and flash it to the device, then
<final-command> is executed.
The IPBSs maintain an internal variable UPDATE/PROT which is initially (or when the device is
reset to factory settings) empty. The prot command will compare the <build-serial> parameter
with the UPDATE/PROT variable. If it is equal, no firmware will be loaded or flashed. If there is
no UPDATE/PROT yet (like for a new device), <build-serial> is compared against the build
number of the current firmware. After a successful download, UPDATE/PROT is set to
<build-serial>. Note that <build-serial> is not checked against the firmware version actually
loaded. It is your responsibility to keep this consistent.
If <url> ends with a slash ('/'), then a default firmware filename is added to the URL depending
on the type of the device (e.g. ipbs.bin).
Firmware Filename
mod cmd UP0 prot http://192.168.0.10/firm ireset 5.0.0
The command above determines if firmware 5.0.0 is already installed. If not, new firmware will
be downloaded fromthe following locations depending on the device type:
IPBS1: http://192.168.0.10/firm/ipbs.bin,
IPBS2:http://192.168.0.10/firm/ipbs2.bin
IPBL: http://192.168.0.10/ipbl.bin
The UPDATE/PROT variable will be set to 5.0.0 and the device will be reset as soon as it is idle.
Similar to the prot command, the boot command will update the boot code.
198
Avaya DECT R4 - Installation and Maintenance Guide
IPBS1
IPSBS2
IPBL
ipbs.bin
ipbs2.bin
ipbl.bin
02/2016