Avaya DECT R4 Installation And Administration Manual page 583

1. Connect a mini-USB type B cable between the USB port on your PC and the management
port on the module. The Found new hardware wizard opens but at this stage the valid
port driver is not present, so close the wizard and continue to install the driver.
2. Press the Mode button twice to change the mode to mass storage.The module will now
turn up as a mass storage device on your computer. This is indicated by slow flashing blue
light on the Mode button LED.
3. Locate the required "elise3.inf" driver and save it on your PC.
4. Press the Mode button twice again to change the mode to network access
new hardware.... dialogue box opens.
5. Select No, not this time and click "Next".
6. Select Install from a list or specific location (Advanced) and click "Next".
7. Select Search for the best driver in these locations.
8. Select the Include this location in the search: check box.
9. Browse to the folder where the port driver is saved.
1. If not pressed within 10 minutes, the module will automatically change to Network access (default mode).
Avaya DECT R4 - Installation and Maintenance Guide
Installing the Elise 3 Server (AIWS2 Hardware)
1
. The Found
583
02/2016