Avaya DECT R4 Installation And Administration Manual page 526

Hide thumbs Also See for DECT R4:

Table of Contents

Installing Elise 2 Server (AIWS Hardware)

Jumper points and push buttons

Module key and Backup battery

Avaya DECT R4 - Installation and Maintenance Guide

Connector for the Compact Flash

Connection of supply voltage

For connection of RS422 communication

Modular jack (RJ45) for connection of RS232 communication. RS232:3

Modular jack (RJ45) for connection of RS232 communication. RS232:2

LON/GP Interface Connector

Modular jack (RJ45) for connection of RS232 communication. RS232:1

Modular jacks (RJ45) for connection of System 900 bus cabling

Connector where an error relay output is available.

Connects AUX Input and AUX Output

For connection of 10baseT or 100baseT Ethernet TCP/IP network

For internal use only

For connection of A or B-bus from System 900 when modular system bus cable

is not used.

Jumper that activates the backup battery. (Jumper pin 2-3 to activate).

For grounding and production test

Jumper that determines if the Error relay output should be active when the relay

operates or is released. Normally set to 1-2 to select operating.

Jumper points for selection of A or B-bus

For internal use only

Jumper points used when Elise 2 Server (AIWS Hardware) controls the

communication on the A/B-bus.

Reset button for CPU

Module address selector switch for A or B-bus. If the setting of SW2 is changed,

the Elise 2 Server (AIWS Hardware) detects this automatically and will reconnect

to the System 900 with the new address (it takes approximately 30 s).

Selector switch for operating mode

Show Quick Links

Table of Contents

Troubleshooting