Avaya DECT R4 Installation And Administration Manual page 207

Scenario 2
Creating an identity
1. Insert the telephone in a desktop charger or rack charger connected to PDM/AIWS.
Note:
The telephone must not have a User ID. If a User ID exists, it can be removed by
Note:
performing a factory reset, see
addition, a valid parameter definition file for the telephone has been imported to
the PDM/AIWS.
2. The Found Device wizard opens. Select Do nothing.
3. In PDM/AIWS, navigate to the Devices tab and locate the telephone in the list of devices.
The telephone is identified by finding the IPDI of the telephone in the Device ID column.
4. Select the telephone, make a right-click, click Assign number... and preferably enter the
extension number for the telephone.
The number that is assigned must not be present under the Numbers tab. If this is the
case, it is recommended to delete the number before Assign number... is performed.
After a few seconds, the Found new number wizard opens. You can save the device in the
database or select Do nothing.
Note:
It is possible to enter any number or name. For IP-DECT systems, it is
Note:
recommended to use the extension number of the phone.This number will now be
the User ID of the telephone. The User ID can be viewed in the telephone by
navigating to the menu:
Settings > Device info > User ID.
Configuring the telephone
In Telephone configuration
1. Configure the telephone using the PDM/AIWS, see
template
Subscribing the telephone
1. 1 Subscribe the telephone towards the DECT system.
The subscription procedure is described in User Manual, Avaya 372x/374x telephone.
In order to easily identify the telephone, both the IPDI and the User ID are shown in the
telephone when initiating the subscription procedure.
Avaya DECT R4 - Installation and Maintenance Guide
on page 218 there are examples of configurations that can be made.
on page 208.
Performing a Factory reset
Configuring a telephone with a
Installation of telephones
on page 210. In
02/2016
207