Avaya DECT R4 Installation And Administration Manual page 584

Installing Elise 3 Server (AIWS2 Hardware)
10. Click "Next". The installation of the port driver begins. If a message opens, saying the
software has not passed Windows Logo testing, click "Continue Anyway".
11. Click "Finish". A dialogue box will open and inform you that new hardware is installed.
Installing the port driver on Windows 7
Note:
When switching between mass storage mode and network mode, it takes about
Note:
30 seconds before the module can be accessed with the 192.5.36.229 address.
1. Connect a mini-USB type B cable between the USB port on your PC and the management
port on the module. The Found new hardward wizard opens but at this stage there is no
valid port driver so close the wizard and continue to install the driver.
2. Press the Mode button twice to change the mode to mass storage.The module will now
turn up as a mass storage device on your computer. This is indicated by slow flashing blue
light on the Mode button LED.
3. Locate the required "elise3.inf" driver and save it on your PC.
584
Avaya DECT R4 - Installation and Maintenance Guide 02/2016