Dect Interface - Avaya DECT R4 Installation And Administration Manual

Installing and operating the AIWS and the AIWS2

DECT Interface

Cordless telephone system
IP-DECT Single Master
Ensure that you configure the interface to the IPDECT Master and IPDECT Standby Masters
from the Wizard. This can also be done from the Advanced Configuration page.
This chapter describes configuration from the Advanced Configuration page, for some carrier
systems. It does not include all supported carrier systems.
Figure 132: Redundancy achieved by connecting AIWS to two IP-DECT base stations
AIWS can communicate with the IP-DECT system over a LAN. For configuration of the
IP-DECT system, see
You can also set an address to a secondary IP-DECT Standby Master which is used as a
redundancy backup. The secondary IP Address is used if the connection to the primary IP
Address is lost. If the secondary IP Address is lost, AIWS will try to use the primary IP Address.
To enter IP-DECT IP address settings, do as follows:
1. On the AIWS Start page, click on Setup Wizard. The Setup Wizard opens.
2. Click Next until you reach DECT IP Address.
3. Enter settings in the fields for DECT IP Address and Secondary DECT IP Address.
4. Set multiple Locations (former IP regions) to no.
IP-DECT multi Master Base Station configuration
For an IP-DECT system with multiple Master Base Stations connected to a single AIWS the
IP-DECT interface settings needs to be changed. In this configuration one IP-DECT interface on
the AIWS is communication with multiple Master Base Stations on the same or different
locations:
1. On the AIWS Start page, click Setup Wizard. The Setup Wizard opens.
440
Avaya DECT R4 - Installation and Maintenance Guide
Installing and operating the IPBS and IPBL on page 63.
02/2016