Accessing The Elise 3 Server (Aiws2 Hardware) - Avaya DECT R4 Installation And Administration Manual

Installing Elise 3 Server (AIWS2 Hardware)
When the Elise 3 Server (AIWS2 Hardware) is running the relay is closed, i.e. the error relay
output is activated when the relay releases, for example if the power is dropped. At power up or
restart the relay is released until the applications are working properly. If the relay is released
longer the Elise 3 Server (AIWS2 Hardware) is malfunctioning.
Connection of AUX inputs and AUX outputs
Note:
The application of the inputs and outputs is software dependent.
Note:
Figure 206: AUX input and outputs
Two digital inputs and two digital outputs can be connected. The outputs are of open collector
type and the output signals are dimensioned for 100 mA at max 12 V. A pull-up resistor should
be connected to the output as shown in figure above. Galvanic isolation of the inputs and
outputs is provided by using a separate power supply. If galvanic isolation is not needed and the
Elise 3 Server (AIWS2 Hardware) is supplied by an external 12 V power source, the supply
voltage can be taken from the 12-24 V DC screw connector by connecting +V Ext to "+" and
GND Ext to "-". The inputs In 1 and In 2 are active when they are connected to 12 V. When the
output Out 1 is active, the potential in point A in above figure will be close to 0 V. The same
applies for a similar connection for Out 2.

Accessing the Elise 3 Server (AIWS2 Hardware)

The Elise 3 Server (AIWS2 Hardware) can be accessed either via an IP network or directly via
the management port (mini-USB). You can access the product´s web interface using browsers
Internet Explorer 8.0™,
580
Avaya DECT R4 - Installation and Maintenance Guide
+V In In Out Out GND
Ext 1 2
+V In In Out Out GND
Ext 1 2
Pull-up
resistor
External
equipment
+12 V DC
Mozilla Firefox 3.6 or later
Error
1 2
1 2 Ext
Error relay output
Error
1 2
1 2 Ext
A
GND
.
02/2016