Avaya DECT R4 Installation And Administration Manual page 177

Click Refresh to update the information.
●
Click Reset to reset the RFP.
●
Synchronizing ring
This section only applies to the IPBL.
A wire map of the synchronization ring is available in the GUI. The identities (IPBL-xx-xx-xx)
of the IPBLs and the position in the ring is displayed. If the ring is broken it is possible to locate
where. Click the IP address to access another IPBL.
1. Select DECT Sync > Sync Ring.
Synchronizing ports
Sync Ports displays the current status of the synchronization ports.
1. Select DECT Sync > Sync Ports.
Status
Sync Offset
Cable Delay
Sync Lost Counter The number of times synchronization lost.
Communication
Connected to
Tx Error
Rx Error
DECT Sync
Air sync overview
This section only applies to the PARI Master.
To see a graphical presentation of the air synchronization in a system, select DECT Sync > Air
Sync Overview.
The internal synchronization for each region is shown separately by an expandable tree view,
see figure 51. The green, yellow and red dots in the sync tree show the following sync status for
the Radios:
Green: Synchronized
●
Yellow: Synchronized but poor received signal strength (RSSI < -83 dBm)
●
Red: Unsynchronized
●
Avaya DECT R4 - Installation and Maintenance Guide
The current status of the port.
The synchronization offset for the IPBL.
The delay caused by the cable.
The present status of communication.
The IP address of the IPBL connected.
The number of transmitting errors.
The number of receiving errors
Operation
177
02/2016