Status Led Indicators - Avaya DECT R4 Installation And Administration Manual

Hide thumbs Also See for DECT R4:

Table of Contents

Installing Elise 3 Server (AIWS2 Hardware)

2. Wait for one minute until the status LED indicates starting up with quick flashing blue light ,

then press the Mode button.The Mode button LED will lit and show fixed blue light

3. Wait untill the Status LED changes to quick flashing yellow light which indicates that the

module has started in Boot Mode(After approximately one minute).

4. Open the web browser and enter the modules IP address to log on.

Starting in unlicensed or demonstration mode

1. Press and hold the Mode button for 10 seconds.The unlicensed or Demonstration Mode is

indicated by the Status LED with slow flashing yellow light and by the Mode button LED

with fixed blue light .

2. To exit the module within the limit of two hours, access the application's web interface.

The module will automatically return to the previous license and parameters (without restart)

after 2 hours. You can also restart the Demonstration Mode after exiting, from the application's

web interface after a delay of 10 minutes. In case you want an immediate restart you can use

the Mode button.

Status LED indicators

Figure 190: Status is indicated by the Status LEDs according to the list below.

Avaya DECT R4 - Installation and Maintenance Guide

Show Quick Links

Table of Contents