Route (Rip) - Allied Telesis x510-28GTX Command Reference Manual

RIP C
OMMANDS
(RIP)
ROUTE

route (RIP)

Overview Use this command to add a static RIP route.
Use the no variant of this command to remove a static RIP route.
Syntax route <ip-addr/prefix-length>
no route <ip-addr/prefix-length>
Default No static RIP route is added by default.
Mode RIP Router Configuration
Usage Use this command to add a static RIP route. After adding the RIP route, the route
can be checked in the RIP routing table.
Example To create a static RIP route to IP subnet 192.168.1.0/24, use the following
commands:
awplus#
awplus(config)#
awplus(config-router)#
Related show ip rip
Commands
clear ip rip route
C613-50170-01 Rev B
Parameter
<ip-addr/prefix-length> The IPv4 address and prefix length.
configure terminal
router rip
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
route 192.168.1.0/24
931