Offset-List (Rip) - Allied Telesis x510-28GTX Command Reference Manual

RIP C
OMMANDS
- (RIP)
OFFSET LIST

offset-list (RIP)

Overview Use this command to add an offset to the in and out metrics of routes learned
through RIP.
Use the no variant of this command to remove the offset list.
Syntax offset-list <access-list> {in|out} <offset> [<interface>]
no offset-list <access-list> {in|out} <offset> [<interface>]
Default The default offset value is the metric value of the interface over which the updates
are being exchanged.
Mode RIP Router Configuration
Usage Use this command to specify the offset value that is added to the routing metric.
When the networks match the access list the offset is applied to the metrics. No
change occurs if the offset value is zero.
Examples In this example the router examines the RIP updates being sent out from interface
vlan2 and adds 5 hops to the routes matching the ip addresses specified in the
access list 8.
awplus#
awplus(config)#
awplus(config-router)#
Related access-list (extended numbered)
Commands
C613-50170-01 Rev B
Parameter Description
<access-list>
Specifies the access-list number or names to apply.
in
Indicates the access list will be used for metrics of incoming
advertised routes.
out
Indicates the access list will be used for metrics of outgoing
advertised routes.
<offset> <0-16> Specifies that the offset is used for metrics of networks
matching the access list.
<interface>
An alphanumeric string that specifies the interface to match.
configure terminal
router rip
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
offset-list 8 in 5 vlan2
925