Ipv6 Nd Minimum-Ra-Interval - Allied Telesis x510-28GTX Command Reference Manual

IP 6 C
V OMMANDS
6 - -
IPV ND MINIMUM RA INTERVAL

ipv6 nd minimum-ra-interval

Overview Use this command in Interface Configuration mode to set a minimum Router
Advertisement (RA) interval for a VLAN interface.
Use the no variant of this command in Interface Configuration mode to remove the
minimum RA interval for a VLAN interface.
Syntax ipv6 nd minimum-ra-interval <seconds>
no ipv6 nd minimum-ra-interval
Default The RA interval for a VLAN interface is unset by default.
Mode Interface Configuration for a VLAN interface.
To set the minimum RA interval for the VLAN interface vlan2, use the following
Examples
commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the minimum RA interval for the VLAN interface vlan2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd ra-interval
Commands
ipv6 nd suppress-ra
ipv6 nd prefix
ipv6 nd other-config-flag
C613-50170-01 Rev B
Parameter Description
<seconds>
Specifies the number of seconds between IPv6 Router
Advertisements (RAs). Valid values are from 3 to 1350
seconds.
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 nd minimum-ra-interval 60
no ipv6 nd minimum-ra-interval
851