Satellite Modem > Configuration > Framing Mode Configuration - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
Selection
Recenter Rx Buffer
Rx Clock Inversion
Rx Filter Rolloff
9.3.8.1.3 Satellite Modem > Configuration > Framing Mode Configuration
Open the nested Framing Mode Configuration page from the Configuration page.
Selection
Framing Mode
EDMAC Mode
EDMAC Slave Address Range
AUPC
Max Power Reached Action
Remote Demod Unlock Action
Target E /N of Remote Demod
b 0
(db)
Maximum Power Limit
Hot Key Description
C
Select to force re-centering of the Plesiochronous/Doppler buffer.
A
Select the Rx clock inversion type:
1 – Normal
2 – Inverted
E
Select the Rx alpha filter rolloff:
1 – 0.35
2 – 0.25
Figure 9-29. Framing Mode Configuration
Hot Key Description
F Select the Framing Mode:
1 – Unframed
2 – EDMAC Framing
3 – EDMAC-2 Framing
D Select the EDMAC Framing Mode:
1 – Unframed
2 – EDMAC Framing
3 – EDMAC-2 Framing
V Set a value from 10 to 9990 in multiples of ten.
A
Select the AUPC operation:
1 – Enable
2 – Disable
R
Select the action:
1 – No_Action
2 – Generate_TX_Alarm
U
Select the action:
1 – Nominal_Power
2 – Maximum_Power
E
Set a value from 0.0 to 9.9.
M Set a value from 0 to 9.
9–46
MN-CDM570A
Revision 3