Figure 72: "User Parameters" Tab (Example); Table 65: Description Of The Parameters - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6
Use Parameters

Figure 72: "User Parameters" tab (example)

The following table explains the parameters listed in the register:

Table 65: Description of the Parameters

User Parameters
Symbolic names
Parameter
Restart on K-Bus Failure
Device Diagnosis
Data Bus Extension
Process Data Representation
Response to PROFIBUS DP
Failure
Response to K-Bus Failure
Startup via DP/V1 Channel
Slot Allocation
Manual
Version 1.0.0
PROFIBUS Master in CoDeSys 2.3
These are used to alter the representation of values
(text coded/binary coded).
Here, set the starting behavior of the slave following an error.
AUTORESET: Automatic starting of the slave
POWER ON RESET: The supply voltage must first be
switched off and then on again so that the slave starts.
Here, activate or deactivate the slave device diagnostics.
Here, indicate whether the internal data bus extension is used
or not.
EEPROM setting is used: Activation of the internal data bus
extension.
EEPROM setting is not used: Deactivation of the internal data
bus extension.
- INTEL (LSB-MSB)
- MOTOROLA (MSB-LSB)
Here, set the behavior of the slave during a PROFIBUS error.
- Substitute values are switched
- Terminal bus stops transmission
- Output image is cleared
- Output image is stored
Here, set the behavior of the slave during a breakdown of the
internal data bus.
- PROFIBUS communication stops
- Input image is cleared
- Input image is stored
Here, activate or deactivate the DP/V1 operating mode.
DP/V1-compatible: To be selected when using CoDeSys.
S7-compatible: To be selected when using the S7 CPU.
147