146 Programming the PFC Using WAGO-I/O-PRO
Figure 57: Dialog Window "Communication Parameters"
6.
In the selection window, mark the required driver in the right side of the
window, Serial (RS-232) 3S Serial RS-232 driver, to configure the serial link
between the PC and the fieldbus controller.
The following properties for the serial port are shown in the center dialog window:
•
Port:
•
Baud rate:
•
Parity:
•
Stop-bits:
•
Motorola byte order:
7.
If necessary, change the entries according to the above values by clicking
on the respective value and editing it.
8.
Confirm these settings by clicking OK
The RS-232 port is now configured for transferring the application.
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
COM1
19200
Even
1
No
WAGO-I/O-SYSTEM 750