Settings Options; Profinet Parameters; Table 28 "Do" (Digital Output) Parameters - WAGO 765-1103/100-000 Manual

Planning

6.3 Settings Options

6.3.1 PROFINET Parameters

"DO" (Digital Output) Parameters
The following table describes the parameters of the "Digital Output" submodule.
Parameter
Group
Digital PD
layout con-
figuration
Digital out-
put substi-
tute configu-
ration
Force mode
setting
Bluetooth
interface
configura-
tion
40 Product manual | Version: 2.2.0
16DO FLD PN DC 24V 2.0A
Parameter Default Value
Value Range
PD layout 0 0: port-
based
1: pin-based Order of the process data of the digital inputs and digital
Digital out- 0 0: set digital
put substi- output pins
tute configu- to low
ration
1: set digital
output pins
to defined
substitute
value
2: hold last
value of dig-
ital output
pins
Digital out- 0 0 ... 65535
put substi-
tute value
Force mode 0 0: enable
setting force mode
1: disable
force mode
Bluetooth 0 0: activation
configura- of BT inter-
tion face is al-
lowed
1: disable
activation of
BT inter-
face. BT in-
terface can-
not be acti-
vated via
optical sig-
nal
Table 28: "DO" (Digital Output) Parameters
Description
Order of the process data of the digital inputs and digital
outputs: port 1 (bit 0 and 1), port 2 (bit 2 and 3), ..., port 8
(bit 14 and 15) (default). For each port, first pin 4, then
pin 2 is transmitted.
outputs: pin 4 (port 1 ... 8), pin 2 (port 1 ... 8).
Set all digital outputs to low level in the event of error
(default).
Set digital outputs to a pre-defined substitute value in the
event of error. If this setting is used, the value of the
"Digital Output Substitute Value" parameter sets the sub-
stitute value.
Hold digital outputs at their last value in the event of an
error.
Substitute value as a bitmask for the digital outputs if the
"Set to Defined Value" setting is used; The input depends
on the "PD Layout" parameter. To assign bits 0 to 15 to
port and pin, see description of the "PD Layout" parame-
ter.
Use a binary-to-decimal converter to calculate this value.
The "Forcing" operating mode may be used (default).
The "Forcing" operating mode must not be used.
®
The Bluetooth interface can be enabled by an optical
signal of a mobile device and in connection with the
WAGO I/O Field app.
®
The Bluetooth interface cannot be enabled by an optical
signal of a mobile device and in connection with the
WAGO I/O Field app.
765-1103/100-000