Configuration Of Snmp V1/V2C Parameters" Page; Table 116: Wbm "Configuration Of Snmp V1/V2C Parameters" Page - "Snmp - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR

15.2.1.2.23 "Configuration of SNMP v1/v2c Parameters" Page

The general settings for SNMP v1/v2c are shown on the "Configuration of SNMP
v1/v2c Parameters" page.
"SNMP v1/v2c Manager Configuration" Group
Table 116: WBM "Configuration of SNMP v1/v2c Parameters" Page – "SNMP v1/v2c Manager
Configuration" Group
Parameters
Protocol enabled
Local Community Name
Click the [Submit] button to apply the changes. The changes only take effect
after the controller restarts. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!
Explanation
It is displayed the SNMP protocol for v1/v2c is
enabled. The local community name is deleted when
the protocol is disabled.
Specify the community name for the SNMP
manager configuration. The community name can
establish relationships between SNMP managers
and agents who are respectively referred to as
"Community" and who control identification and
access between SNMP participants.
The community name can be up to 32 characters
long and must not include spaces.
To use the SNMP protocol, a valid community name
must always be specified. The default community
name is "public."
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 213
Manual