WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.4.12
"SNMP" Menu
This menu contains other submenus with the SNMP settings.
Table 184: "SNMP" Menu
Parameters
0. Back to ...
1. General SNMP
Configuration
2. SNMP v1/v2c Manager
Configuration
3. SNMP v1/v2c Trap
Receiver Configuration
4. SNMP v3 Configuration
5. SNMP firewalling
6. Secure SNMP firewalling
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.4.12.1 "SNMP" > "General SNMP Configuration" Submenu
This submenu contains the general SNMP settings.
Table 185: "SNMP" > "General SNMP Configuration" Submenu
Parameters
0. Back to ...
1. SNMP status
2. Name of device
3. Description
4. Physical location
5. Contact
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Back to the higher-level menu
Opens a submenu with general SNMP settings
Opens a submenu with settings for the SNMP
v1/v2c Manager
Opens a submenu with settings for the SNMP
v1/v2c trap receivers
Opens a submenu with settings for the SNMP v3
configuration
Opens a submenu with firewall settings for SNMP
Submenu Item / Explanation
Back to the higher-level menu
Enable or disable the SNMP service.
0. Back to ... Back to the higher-level menu
1. Enable
The SNMP service is enabled.
2. Disable
The SNMP service is disabled.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Commissioning 211
Manual