Table of Contents
Advertisement
54
Operating Modes
In this window under Connection select "Serial ports (COM, USB,
Bluetooth, ...)" and under Port "COM1: Communications port".
Then confirm this selection by clicking [OK].
4.
Switch on the supply voltage to your coupler/controller.
When the coupler/controller has booted up click [Identify] on the toolbar.
5.
The set-up of your fieldbus node will be automatically detected and shown
graphically in the node view and also in the navigation bar as a tree
structure.
6.
Move the mouse pointer to the graphical representation of the HART I/O
module or to the I/O module designation "0750-0482" in the tree structure
and select Settings from the context menu (right mouse button).
Figure 26: WAGO-I/O-CHECK context menu „Settings"
7.
In the dialog window that opens for making the settings select the required
operating mode and then click [Write].
Figure 27: WAGO-I/O-CHECK Dialog Window "Settings for 0750-0482"
When the parameters have been set successfully, this will be indicated by a
message.
Manual
Version 1.2.0
WAGO I/O System 750
753-482 2AI 4-20mA 12 Bit S.E. HART
Advertisement
Table of Contents
