Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.1.32
"Configuration of General SNMP Parameters" Page
The general settings for SNMP are given on the "Configuration of General SNMP
Parameters" page.
7.8.1.32.1 "General SNMP Configuration" Group
Table 93: WBM "Configuration of General SNMP Parameters" Page – "General SNMP Configuration"
Group
Parameter
Service active
Name of device
Description
Physical location
Contact
Click the [Submit] button to apply the changes. The changes only take effect
after restarting the controller. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Activate/deactivate the SNMP service.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Commissioning 149
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
