Common; Figure 17: Parameter „Common; Table 32: "General" Parameters - WAGO 750 Manual

54 Commissioning
7.1.3.1

Common

Figure 17: Parameter „Common"
The following I/O parameters can be set through the menu Common:

Table 32: "General" Parameters

Selection Field
Number format
Siemens S5 format
Input filter frequency
* Default setting
The settings are transmitted to the I/O module using the [Write] button.
Save settings!
Click the [Write] button to transmit any settings that have been made to the I/O
module!
Manual
Version 1.0.0
All manuals and user guides at all-guides.com
Settings
There are two ways the process image can be
represented on the fieldbus:
Two's complement*
Amount/sign
This can be used to fade in status indicators in the lowest
three bits.
On Bit 0 = Overrun
Bit 1 = Error
Bits 0 and 1 are set for wire breaks / overloads and
measurement over- and underranges (when the
corresponding channel diagnostics is set).
Bit 2 = Always 0
Off* No display of status indicators
The input filter is used to suppress interfering mains
frequency signal components. The frequency depends on
the application location and can be set with module
granularity.
50 Hz* The mains frequency is 50 Hz (e.g., Europe).
60 Hz The mains frequency is 60 Hz (e.g., USA).
WAGO-I/O-SYSTEM 750
750-471 4AI U/I Diff Galv