Configuration Of General Snmp Parameters" Page; Table 104: Wbm "Configuration Of General Snmp Parameters" Page - "General - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100

15.1.1.2.21 "Configuration of General SNMP Parameters" Page

The general settings for SNMP are given on the "Configuration of General SNMP
Parameters" page.
"General SNMP Configuration" Group
Table 104: WBM "Configuration of General SNMP Parameters" Page – "General SNMP
Configuration" Group
Parameter
Service active
Name of device
Description
Physical location
Contact
Object ID
Click the [Submit] button to apply the changes. The changes only take effect
after restarting the controller. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!
Explanation
Activate/deactivate the SNMP service.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Enter here the object ID (sysOID).
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 171
Manual