Configuration Of General Snmp Parameters" Page; Table 115: Wbm "Configuration Of General Snmp Parameters" Page - "General - WAGO I/O System 750 Manual

212 Appendix

15.2.1.2.22 "Configuration of General SNMP Parameters" Page

The general settings for SNMP are given on the "Configuration of General SNMP
Parameters" page.
"General SNMP Configuration" Group
Table 115: WBM "Configuration of General SNMP Parameters" Page – "General SNMP
Configuration" Group
Parameter
Service active
Name of device
Description
Physical location
Contact
Object ID
Click the [Submit] button to apply the changes. The changes only take effect
after restarting the controller. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Explanation
Activate/deactivate the SNMP service.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Enter here the object ID (sysOID).
WAGO I/O System 750