Table 142: Description Of The Configuration Scripts For " General Snmp Information Parameters - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-131 WAGO-I/O-IPC-C6

Table 142: Description of the configuration scripts for " General SNMP information parameters "

Parameter
General SNMP information parameters
Name of Device
Description
Physical
Location
Contact
* When entering values, the blank characters must be filled by either "+" or "%20". Otherwise, the
input is not detected as a coherent string.
SNMP Manager Configuration for v1 and v2c
Protocol Status
Local
Community
Name
Protocol Status/
Community
Name
SNMP Trap Receiver Configuration for v1 and v2c
Any number of trap receivers can be configured. A trap receiver that has been set up is always
active; the data set must be completely deleted to deactivate it.
Manual
Version 1.0.0
Status Call
get_snmp_data
read
device-name
config_snmp
write
device-name=<value>
get_snmp_data
read
description
config_snmp
write
description=<value>
get_snmp_data
read
physical-location
config_snmp
write physical-
location=<value>
get_snmp_data
read
contact
config_snmp
write
contact=<value>
get_snmp_data
read
v1-v2c-state
get_snmp_data
read
v1-v2c-community-name
config_snmp
v1-v2c-state=<value1>
write
v1-v2c-community-
name=<value2>
Appendix
Output/Input
Specify the SNMP
"sysName" parameter
Change the SNMP
"sysName" parameter
(<value> = string). *
Specifies the SNMP
"sysDescr" parameter.
Changes the SNMP
"sysDescr" parameter
(<value> = string). *
Specifies the SNMP
"sysLocation" parameter.
Changes the SNMP
"sysLocation" parameter
(<value> = string). *
Specifies the SNMP
"sysContact" parameter.
Changes the SNMP
"sysContact" parameter
(<value> = string).
Returns the SNMP protocol
status for v1/v2c as a string:
enabled
disabled
Specifies the community
name set for v1/v2c/
Activates/deactivates the
v1/v2c protocol (<value1>
= enabled or disabled) and
assigns a community name.
(value2> = string without
blank characters, min. 1,
max. 32 characters).
Note:
No community name is
required for deactivation.
Activation is only possible
by entering a community
name. Saving the
community name is only
possible if the protocol is
activated.
271
Validity
immediate
after restart
immediate
after restart
immediate
after restart
immediate
after restart
immediate
after restart