Table of Contents
Advertisement
3.1.10.1.1
System Group
The System Group contains general information to the coupler/controller.
Identifier
1.3.6.1.2.1.1.1
1.3.6.1.2.1.1.2
1.3.6.1.2.1.1.3
1.3.6.1.2.1.1.4
1.3.6.1.2.1.1.5
1.3.6.1.2.1.1.6
1.3.6.1.2.1.1.7
3.1.10.1.2
Interface Group
The interface Group contains information and statistics to the device interface.
Identifier
1.3.6.1.2.1.2.1
1.3.6.1.2.1.2.2
1.3.6.1.2.1.2.2.1
1.3.6.1.2.1.2.2.1.1
1.3.6.1.2.1.2.2.1.2
1.3.6.1.2.1.2.2.1.3
1.3.6.1.2.1.2.2.1.4
1.3.6.1.2.1.2.2.1.5
1.3.6.1.2.1.2.2.1.6
1.3.6.1.2.1.2.2.1.7
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
Fieldbus Controller 750-872/020-000
Entry
Ac-
cess
sysDescr
R
sysObjectID
R
sysUpTime
R
sysContakt
R/W This entry contains the identification of the
sysName
R/W This entry contains an administrative name
sysLocation
R/W This entry contains the physical place of
sysServices
R
Entry
Ac-
cess
ifNumber
R
ifTable
-
ifEntry
-
ifIndex
R
ifDescr
R
ifType
R
ifMtu
R
ifSpeed
R
ifPhysAddress
R
ifAdminStatus
R/W This entry indicates the desired condition of
Fieldbus Controller
Description
This entry contains the device identification.
The entry is fix coded e. g. on
"WAGO 750-872/020-000".
This entry contains the authorizing
identification of the manufacturer.
This entry contains the time in hundredth
seconds since the last reset of the
managements unit.
contact person and contains information
about the contact possibilities.
for the device.
installation of the node.
This entry designates the quantity of services,
which this coupler/controller contains.
Description
Number of network interfaces in the system
Number of network interfaces
Entry network interface
This entry contains an unique assignment
number for each interface
This entry contains the name of the
manufacturer, the name of the product and
the version of the hardware Interface. E. g.
"WAGO Kontakttechnik GmbH
750-872/020-000: Rev 1.0"
This entry describes the type of the
interface. Ethernet-CSMA/CD = 6,
Software-Loopback = 24
This entry specified the maximum transfer
unit (i.e. the maximum telegram length over
this interface to be transferred can).
This entry indicates in bits the speed of the
interface.
This entry indicates the physical address of
the interface. In the case of Ethernet this is
the MAC-ID.
the interface. Possible values are here:
up(1) : Ready for use to sending and
receiving
down(2) : Interface is switched off
testing(3) : Interface is in the test mode
• 99
Advertisement
Table of Contents
