Firewall Parameters Interface Xxx" Group; Table 56: Wbm "General Firewall Configuration" Page - "Firewall Parameter - WAGO 750-8207 Manual

118 Commissioning

7.8.1.10.2 "Firewall Parameters Interface xxx" Group

These settings in this group refer to the configuration of the firewall at IP level.
Table 56: WBM "General Firewall Configuration" Page – "Firewall Parameter Interface Xn" Group
Parameters
Firewall enabled for
Interface
ICMP echo protection
ICMP echo limit per second
ICMP burst limit
(0 = disabled)
Service enabled
Click [Submit] to apply the change. The change is effective immediately.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
Enable or disable the firewall for the specific
interface.
Enable or disable the "ICMP echo" protection for the
respective interface.
You can specify the maximum number of "ICMP
echo bursts" per second.
You can specify the maximum number of "ICMP
echo bursts" per second.
"0" = "Disabled"
Telnet
FTP
FTPS
HTTP
HTTPS
I/O-CHECK
PLC Runtime
PLC WebVisu –
direct link (port 8080)
SSH
TFTP
BootP/DHCP
DNS
MODBUS TCP
MODBUS UDP
SNMP
WAGO-I/O-SYSTEM 750
Enable or disable the
firewall for the respective
service.
The services themselves
must be enabled or
disabled separately on the
"Ports and Services" page.