Specifying A Full-Wide Blade; Specifying A Server Blade In Smp Configuration; Roles; How To Specify And Display The Ip Address - Hitachi Compute Blade 500 Series User Manual

When all is specified to a number, such as a server blade slot number, in
some commands, the command is executed for all slot numbers. Whether
or not all is available depends on the command. See description of each
command for details.
Tip: When all is specified, which includes non-target slot numbers due to
some server blade uninstalled, the following message appears at the end of
the command even if the processing is successful for all slot numbers
installed.
S0004: Command succeeded partially.

Specifying a full-wide blade

A full-wide blade occupies two slots for half-wide blades. When specifying a
full-wide blade as a server blade using CLI command, specify a slot with a
smaller number, even number, of the two slots to be occupied.

Specifying a server blade in SMP configuration

SMP configuration consists of multiple server blades: one is the primary
server blade and the others are non-primary server blades. Which server
blade is specified depends on the commands, which is described in each
command section. For details about SMP configuration, see the Hitachi
Compute Blade 500 Series System Overview Guide.

Roles

For details about roles and privileges required, see the Hitachi Compute Blade
500 Series Management Module Setup Guide.

How to Specify and Display the IP Address

You can use both IPv4 and IPv6 addresses. Different commands and
parameters are used for each type of address. Refer to the descriptions below
for each command.
How to specify IPv4 addresses
Specify IPv4 addresses in accordance with the following rule:
• Divide the 32 bits of the IPv4 address into four fields of eight bits each.
Express the value of each field as a decimal number from 0 to 255, and
separate each field with a period (.).
Example: 10.200.3.4
How to specify IPv6 addresses
Specify IPv6 addresses in accordance with the following rules:
2-4
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide