Network Address Setting - Hitachi Compute Blade 500 Series User Manual
Hide thumbs
Also See for Compute Blade 500 Series:
- User manual (456 pages) ,
- Management module setup manual (362 pages) ,
- Web console users manual (240 pages)
Table of Contents
Advertisement
Tip:
•
•
5
Go back to the Controller Configuration setting menu by ESC.
.
Network address setting
1
When the Controller Configuration setting menu is displayed, select
.
Network Configuration and press Enter.
2
When the Network Configuration setting menu is displayed, confirm
.
that Link Status is displayed Link Up. Select Configure Static IP
Address by Tab and press Enter.
Note:
•
•
Tip: If Link Status is displayed Link Down, the CNA port does not have
links to the internal 10Gb LAN switch. Check the network configuration or
the setting of internal 10Gb LAN switch is correct or not.
3
Enter "IP Address" and "Subnet Mask".
.
Note: Do not set "Default Gateway".
Then, select Save and press Enter.
9-8
When Boot Support is Disabled, change to Enabled and press
Save.
Discover Boot Target via DHCP is not available.
VLAN ID/Priority function is not available.
DHCP function is not available.
iSCSI settings
Hitachi Compute Blade 500 Series EFI User's Guide
Hide quick links:
Advertisement
Table of Contents
