Ip Address - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

This function and the function for connecting MGMT1 to the management
interface are available at the same time. You can build the following
configuration.
• The management module and switch module connect to MGMT0 without
VLAN. The server blades #0 – 3 connect to MGMT0 using VLAN ID 10 –
13. The server blades #4 – 7 connect to MGMT1 using VLAN ID 20 – 23.
You can separate the network according to the purpose and load balance.
Note: "VLAN ID: 1 and 4001 to 4094" are used in the system unit, so you
cannot use these VLAN IDs.
Tip: When using this function, the external switch must support the
IEEE802.1Q VLAN.

IP address

The management interface settings for each module is configured through the
management module. You can set both IPv4 and IPv6 addresses for the
features that support IPv6 networks. Items indicated as IP addresses are
either an IPv4 address or an IPv6 address.
IP address settings at shipping time
The following table describes the IP address of factory default network
setting. IPv6 addresses are disabled.
2-18
Hitachi Compute Blade 500 Series Management Module Setup Guide
Figure 2-5 System unit configurations for Tag-VLAN
Functional detail