At Cancel; Write Mode - Omron E5AR-T User Manual

■ AT Cancel

Command
Response

■ Write Mode

Command
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'0A
1 1 2
Related
information
Ch
H'00 1
H'10 2
H'20 3
H'30 4
H'F0 All
This command cancels AT.
This command is used in setting area 0. An operating error will occur if
it is used in setting area 1. An operation error will also occur in the
following cases:
• If the Run/Reset parameter is set to "Reset" for the
specified channel
• If the Auto/Manual parameter is set to "Manual" for the
specified channel
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'0A
1 1 2
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'04
1 1 2
Related
Description
information
H'00 Backup Mode
H'01 RAM Write Mode
This command is used to select the Backup Mode or RAM Write
Mode.
The default setting is "Backup Mode."
This command can be used in both setting area 0 and setting area 1.
7.9 Commands and Responses
Related
information CRC-16
2 2
Description
Command mode
AT Cancel
AT Cancel
AT Cancel
AT Cancel
AT Cancel
Related
information CRC-16
2 2
Related
information CRC-16
2 2
7-27