Omron E5AR-T User Manual page 378

Output
Type
Bit:
31 30 29 28 27 26
0
Note 1. Status is as follows when reading from setting area 1:
• RSP input error:
• Potentiometer error:
• Display range exceeded:
• Input error:
• Control output (heating), control output (cooling):
• Alarm 1, Alarm 2, Alarm 3, Alarm 4:
• AT:
• Run/Reset:
• Auto/Manual:
• SP mode, MV tracking:
• Control output (heating) type, control output (cooling) type:
2. If the FSP Mode is set to "ON," the SP Mode parameter setting (RSP/RSP) is ignored. If the FSP
Mode is set to "OFF," the SP Mode parameter setting (RSP/RSP) is valid and the Program SP Mode
and Remote SP Mode can be used as required.
3. The control output (heating) status and control output (cooling) status are the open output status
and close output status, respectively, during position-proportional control.
4. The control output (heating) status and control output (cooling) status are OFF during linear output.
5. The control output (heating) type status and control output (cooling) type status are OFF when the
corresponding output is a pulse voltage output.
Operating status
25 24 23 22 21 20 19
0
18 17 16 15
0 0 0
Status
Not used
Not used
Not used
Not used
Write Mode
EEPROM
Setting Area
AT Execute/Cancel
Run/Reset
Communications Writing
Auto/Manual
SP Mode
Not used
FSP Mode
Control Output
(Heating) Type
Control Output
(Cooling) Type
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
Cleared
ON (Reset)
Previous value held
Updated
Updated
Setting Lists
0 (OFF) 1(ON)
OFF
OFF
OFF
OFF
Backup RAM write
RAM = EEPROM RAM EEPROM
Setting area 0 Setting area 1
AT stopped AT in progress
Run Reset
OFF (disabled) ON (enabled)
Auto Manual
Local SP (LSP) RSP
OFF
OFF (PSP/RSP) ON (FSP)
Pulse voltage Linear current
output output
Linear current
Pulse voltage
output
output
A-9