Installation Procedure - Omron E5AR-T User Manual

● Installation Procedure
If the front of the Controller
needs to be watertight, attach
the enclosed watertight
packing.
If the front of the Controller
does not need to be water-
tight, the watertight packing
does not need to be attached.
Insert the Controller into the
cutout in the panel.
Insert the enclosed fittings
into the grooves on the top
and bottom of the rear case.
Gradually tighten the screws
in the top and bottom fittings,
alternating between them so
that they are balanced.
Tighten the screws until the
ratchet turns freely (i.e., until
the screws are no longer
engaged).
● Pulling Out the
Controller
E5AR-T
Watertight packing
Normally there is no need to pull out the Controller. However, it can be
pulled out if needed for maintenance purposes.
1
2
1
When pulling out the Controller, place a cloth over the screwdriver to
prevent scratches and other damage.
2.1 Installation
E5ER-T
Watertight packing
2.0
0.4
2-3