Response
■ Advance
Command
Response
This command starts or cancels the hold operation.
This command is used in setting area 0. An operation error will occur if
it is used is setting area 1.
Operation errors will also occur in the following cases:
• If AT is being executed
• If the specified channel is being reset or is on standby
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC
SRC
Response code
" 30"
"05"
" 0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Instruction
Related
MRC
SRC
code
information
"30"
"05"
"13"
Related
information
Ch
"00"
1
"10"
2
"20"
3
"30"
4
"F0"
All
This command executes an advance operation. Operation will move to
the beginning of the next segment.
This command is used in setting area 0. An operation error will occur if
it is used is setting area 1.
Operation errors will also occur in the following cases:
• If AT is being executed
• If the specified channel is being reset or is on standby
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC
SRC
Response code
" 30"
"05"
" 0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
6.9 Commands and Responses
Description
Command mode
Advance
Advance
Advance
Advance
Advance
6-35